Part Two of a Two-Part Series
(see Part One of this series here )
Design Challenges
In undertaking this very large remodeling project, Acheson Builders had many challenges. One good example: we didn’t want to block a feature window that is at the front of the house while adding a new staircase to replace a vintage narrow straight run set of steps (see part one of this series for solution). The homeowners also asked us to create a coat-closet space for that part of the house.
To accomplish this, we designed the new stairs with a turn midway up, so that the upper section of stairs along the front wall could be above the feature window. We were then able to fit a small coat closet under the upper stairs, while adding a bonus hidden storage area under the lower section of stairs. All done in period detail.
When it comes to working on older homes such as this that are considered historic, contractors such as Acheson Builders must hue to the call of the Historic District Commission of Ann Arbor, Michigan. One governing rule of the HDCAA specifies that additions to classic homes in its purview look different than the historic parts of those houses. For this 1840’s home, there were four different styles incorporated, each from a different design era. Although required to have the addition look different, Acheson Builders and the home’s owners didn’t want it to look drastically different — we wanted some continuity, a sense of a unified building after integrating the new with the old. Part of our solution was to use existing ornamentation, seen in the taller front section of the house, as inspiration for the embellishment used on the rear addition.
One somewhat painful decision that the owners had to make involved losing an outdoor sauna. Acheson Builders replaced a badly deteriorating old deck and sauna with a new deck (but no sauna) built on the sunnier side of the house, which also allowed for a larger addition, while at the same time including value-added maintenance-free Azek PVC materials.
One challenge with using Azek materials for the deck and railing, was that Azek does not make a top handrail for stairways that qualifies as “graspable” under the building code. We were able to solve this issue by custom-fabricating, using Azek stock, a top guardrail for the steps that conformed to the code but which also matched the profile of the manufactured top rail used along the level guardrail sections. To fabricate this required handrail, we glued Azek stock pieces together, then milled them for the desired profile. This type of work is quite sophisticated and is only done well by highly skilled carpenters (such as ours)!
Some Design Process Considerations for this job:
- Deck Height: House sits high relative to the backyard; deck needed to be just a step or two down: this allows for a better view of the yard from inside the house while taking minimal space away from the deck
- Embellishment: New entryway to deck and backyard from Kitchen and Family Room creates a stunning look as seen from both interior and exterior perspectives; it is a highlight and new rear focal point, with inspiration from other portions of this historic home
- Addition and deck size: allow for good furniture layout, walkability, storage (both interior spaces, and on deck itself)
- Width of deck stairway: wide design allows for traffic flow to yard, room to sit on steps
- Additional features and thoughtful design: one of the skirt panels below the deck opens, so the space is accessible for storage under the deck
. . . and on and on, so forth and etc.; there were a myriad of other issues, both interior and exterior in this the complex design and remodeling process, especially for issues relating to an historic home. Challenging and satisfying — for the homeowners and for Acheson Builders!
— Go back to Part One of this series —
###
